How To Improve The Performance Circuit Board Design

- Jul 06, 2017-

Improve the performance of mobile phone circuit board design audio performance

Mobile phone circuit board design to improve the audio performance should be:

1. Consider the underlying plan carefully.

 

The ideal underlying plan should divide the different types of circuits into different areas.

2. Use differential signals whenever possible.

 

Audio devices with differential inputs can suppress noise. Differential signal in the middle of the general can not add ground. Because the application of differential signals is the most important point is the use of differential signals between the benefits of coupling, such as magnetic flux elimination, anti-noise ability. If the ground wire in the middle, it will destroy the coupling effect.

Differential pairs of wiring there are two points to note that the length of the two lines should be as long as possible, the other is the distance between the two lines (this distance determined by the differential impedance) to remain the same, that is, to keep parallel. There are two parallel ways, one for the two lines walk in the same line layer (side-by-side), one for the two lines in the upper and lower adjacent two layers (over-under). Generally in front of the side-by-side to achieve more ways.

3. Isolate the ground current to avoid the digital current to increase the noise of the analog circuit.

 

Basically, it is right to divide the modulus / division. It should be noted that the signal trace as far as possible not across the division of the place, and do not let the power and signal return current path changes too much. Digital signal signal can not cross the request because the speed of the digital signal is slightly faster to return the current path will be as far as possible below the bottom of the line to return to the source of digital signals, if the number of signal lines cross, the return current The resulting noise will appear in the analog circuit area.

The analog circuit uses star ground. The current consumption of audio power amplifiers is generally large, which may have an adverse effect on their own ground or other reference ground.

The unused area on the circuit board into a ground plane. Grounding coverage is achieved near the signal trace to divert excess high frequency energy from the signal line to the earth by capacitive coupling.

 

Mobile phone board design improves audio performance should not:

 

4. Use a hybrid circuit on the board.

 

Although the radio frequency area of the handset is generally considered to be analog, the noise coupled from the RF zone to the audio circuit is demodulated to be audible.

5. Analog audio signal wiring is too long.

 

Too long analog audio stitches may be subject to noise from digital and RF circuits.

6. forget the importance of grounding loops.

 

Poor grounding system will be serious distortion, noise, crosstalk and RF immunity and other issues.

7. Disconnect the digital circuit from the natural current.

 

This path produces a minimum loop area that reduces antenna and inductance effects.

8. Ignore the location of the bypass capacitor to be placed close to the power supply pin that may be bypassed.


Previous:Every Layer Meaning For PCB Design Next:Pcb Manufacturing Processing